Perefleshivanie NOKIA phones became available thanks to Flasher Dejana and its special replacement consoles TDF-4, which is worth more than a thousand dollars! Dejan made the first device for home use, which problems can be removed without SIM-Lock with new phones NOKIA. They were so protected that none of the program (NOKIA tool, All Nokia) they are not snimaet. Naprimer the Nokia 3210 v5.31, v5.36, v6.00, etc. Based on substitution Flasher programmable fragment, which is responsible for the lock. For this purpose, special Partail-Flash, buyout replace a piece, but without the SIM-Lock. Perefleshivanie entire phone (with the start address 000000 to 0040000) is impossible Dejan Flasher-ohm. To do this, have a device (TDF-4), thanks to which you can not only change the Flash, but Eeprom. If you still decide to try perefleshit your phone data with cell flasherom 000000 to 0030000 – 0040000 or up, then your phone is in consequence not find the network! The same effect would be if you try to change the language in the phone.

Flasherom Dejana can unlock with the new phone models. Privert models and their firmware versions – below. Firmware version can be found by entering the code * # 0000 # even without the card. Version of firmware can also learn and use the program LogoManager.
Nokia 5110 v5.28, v5.29, v5.30
Nokia 5130 5.71
Nokia 3210 v5.31, v5.36, v6.0
Nokia 3310 v3.24, v4.02, v4.06, v4.18, v4.19, v4.23, v4.24, 4.35
Nokia 6150 v5.22, v5.23
Nokia 6210 v3.01, v3.04, v3.74, v4.08, v4.27, v4.36, v5.01, v5.02
Nokia 7110 v4.88, v4.94, v5.00, v5.01
Nokia 8210 v5.08, v5.11, v5.16, v5.20, v5.21, v5.25, v5.26
Nokia 8250 v3.08, v3.12
8290 v5.06
Nokia 8850 v5.11, v5.16, v5.20, v5.21, v5.25, v5.26, and other versions
Flasher Dejan phone can be brought to the state when the display will say “Contact service”, it is connected with nekorektnoy work when removing the block. This can be rectified if fill your phone with original flash version of this phone

Flasher Dejana simple scheme. It can make the most of the scheme, or to buy. The second figure shows how this looks already completed Flasher, which can be purchased.

1. What do I need to work: The Nokia with a new firmware version (you can find the code * # 0000 # or program Logo Manager), Interface Dejana, made under the scheme, or purchased. Reflash your phone does not turn out cable type: MBUS, FBUS or Universal. Program Dejan Flasher.Sootvetstvuyuschy f_loader.bin and file boot.bin Files Partial-Flasha. They have the extension *. fls and each one weighs no x 64Kb, Port LPT.

2. Training program to work on a local disk (np. C: \) to make a directory flasher (c: \ flasher), which must raspakavat program, in case you what you did wrong, is this message:
- Or similar. In any case, it means that the Programs at not properly installed. Then you must create a directory nk_files (c: \ nk_files). It should copy all the partial-flashe, which will be replaced by a soft phone, and files: boot.bin and f_loader.bin (file type f_loader.bin used to read and write flash) according to the model and firmware version. Normally: Intel16, InterW 8, IntelW 16, Atmel 8, St 32. And finally Fail c: \ flasher \ flasher.com. The program starts.

3. How to Backup (copy of the security) – This is very important!

You must run the file c: \ flasher \ flasher.com then press F1 (Read Phone), a list of phone models (see Figure below)

Arrow keys choose the appropriate phone model and press Enter. Program then asks about the start address (start adress). Address take with partial (np. for Nokia 3210 5.31 start address 00260000) and enter in the field (see Figure below)

After pressing Enter. It remains to specify the destination address, which is more starting to 10000 (in our prmere 00270000) – Fig. below

Press Enter, the program started to work:

Connecting Turning off phone to cable (without SIM-card) and again press Enter. Then quickly for a short time, turn on the phone, it should be done very quickly, otherwise the program will not start reading! In some phones like the Nokia 3210 does not necessarily include it. (But better to include)

Now the program starts to work on creating Backup. Program to save the file c: \ flasher \ flash.out, size 65536 bytes (if the amount is less, must select another file f_loader.bin). Then you must disconnect the phone from the flasher, wait a bit, pull out the battery and attach again. Then Nemeshaev would change the extension Backup c: \ flasher \ flash.out to *. fls (np. backup.fls). This is our copy of the security. Best course to make a copy of the full flush, in case something went wrong.

4. Flashovanie phone – the removal of Sim-locka

After creating a copy of the security (ie Backup’u) you can start flashirovaniyu. To do this, again, run the file c: \ flasher \ flasher.com then press F2 (Write data to Flash). A list of phone models. You must select your model and confirm by pressing Enter

A Novi list with partial-flash, which resides in c: \ nk_files

From this list, select our versiyayu firmware and press Enter. Then enter a starting address, just as we did when reading flash and press Enter. The program asks to connect again turned off the phone to flasher Dejana. Connecting and press Enter and quickly press the Power On (not applicable to Nokia 3210). If everything is OK, the phone will reflash. At the end you must disconnect the phone from the cable, wait a bit and pull the battery, then put it back into place. If the phone is normally enabled, it no longer has a sim-lock’a.

5. Troubleshooting, if your phone is not switched on or not working as it should, it is necessary perefleshit *. fls file, which we did in the beginning (backup flash). Backup starts from 0020000 to 0030000 (or the other, depends on phone model).